WHEN YOU DEMAND HIGH QUALITY AND ACCURACY, GO WITH........ SPEED CITY !
DRIVER FIGURE IN DRAGSTER INSTRUCTIONS
Here I'll show you how to add a "SPEED CITY RESIN" Driver Figure #2 to fit into your dragster.
I'm using the 2 "Short Arms" from the Speed City Resin "Driver Figure #2" for this project.
First, the back of the knees were cut into a pie section. A lighter was used to heat the legs to make them fit around the axle.
The arms were thinned on the outside and inside of the arms. The back of the legs were altered to rest on the rear end.
The arms are set to hold a steering wheel.
Arms before putty.
Legs before putty.
I placed Saran Wrap in the seat, then puttied up the figure and then pushed him into seat to get a perfect fit.
After cleaning up the putty on the arms.
After cleaning up the putty on the legs.
Tools I used to do all the putty clean up.
Using the steering wheel from the AMT Don Garlits "Wynnsjammer" Dragster.
Driver is completed !
